BEST ACCESS SYSTEMS 45HM IDH Max Mortise Locks Especificaciones descargar pdf (Pagina 3)

Installation Instructions for 45HM IDH Max® 1300 Mortise Locks

BEST ACCESS SYSTEMS

a Division of Stanley Security Solutions, Inc.

Installation Instructions for 45HM IDH Max® 1300 Mortise Locks

3 Drill wire channel through door

Caution 1: Check with your local fire marshal

before drilling a fire-rated door. Drilling through

a fire-rated door may void the fire label.

Caution 2: Be careful to drill straight through the

door, making sure the drill does not break

through the face of the door.

1 Remove the hinge nearest the mortise cavity.

2 Using a 3 to 4 foot drill bit, drill a 3/8″ diameter

channel through the upper back of the mortise cavity

to the center of the nearest hinge mortise.

See Figure 3.

Note: It may be easier to drill halfway from each side of

the door.

4 Optional: Prepare door for door status

switch (for deadbolt function locks with

door sensing only)

1 Locate the centerpoint for the door status switch 2.5″

above the top of the faceplate mortise on the edge of

the door (as shown in Figure 4).

2 Drill a 1″ diameter hole 1 3/4″ deep for the door

status switch.

3 Position the drill so the tip of the bit is approximately

1″ into the hole and the bit is close to the top edge of

the hole. Then drill a 3/8″ channel at approximately a

35° angle from the door status switch hole into the

mortise cavity (as shown in Figure 4).

Figure 3 Drilling the wire channel through the door

Hinge mortise

Figure 4 Preparing for the door status switch

Door status

switch hole

3/8″

channel

1 2 3 4 5 6 7 8 ... 19 20

Sin comentarios

BEST ACCESS SYSTEMS 45HM IDH Max Mortise Locks Especificaciones Pagina 3