BEST ACCESS SYSTEMS 35HW Manual de servicio descargar pdf (Pagina 29)

IDH Max Locks Functions and Parts

W Series Service Manual 2–15

READER CONVERSION

Mortise or

cylindrical reader

conversion

If you want to convert the reader of an existing mortise or cylindrical

IDH Max Lock, use the following table to determine the parts that you

need. You will also need to replace the outside escutcheon

gasket (A60725). This table includes only the parts that are different.

Note: You do not need to change the position of the DIP switches on

the control electronics circuit board.

■ By default, switches 1 through 5 are set to ON. These switches are

for possible future applications.

■ By default, switches 6 and 7 are set to ON for automatic baud rate

detection. This setting lets you determine the baud rate for

communication between the lock’s control electronics circuit board

and the panel interface module by setting DIP switches on the panel

interface circuit board.

■ Switch 8 is set to ON only for locks with a magnetic stripe insertion

card reader; it is set to OFF for locks with a magnetic stripe swipe

card reader.

Caution

Before you handle the circuit board or any component on the circuit

board, make sure that you are properly grounded using an

electrostatic discharge (ESD) protection kit. Touching the circuit

board without proper grounding can damage sensitive electronic

components—even if you don’t notice any static discharge.

Figure 2.6 Location of the DIP switch on the control electronics circuit board

DIP switch

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 227 228

Sin comentarios

BEST ACCESS SYSTEMS 35HW Manual de servicio Pagina 29