
Contents
W Series Service Manual v
Replacing mortise case components 4–51
Replacing the solenoid 4–51
Replacing the RQE switch 4–52
Replacing the door status switch 4–53
Replacing the latch status switch 4–55
SERVICE AND MAINTENANCE FOR CYLINDRICAL LOCKS 5–1
Replacing IDH Max Cylindrical Locks 5–2
Replacing components for electrified cylindrical locks 5–19
Adding the RQE switch to electrified cylindrical locks 5–25
Reversing the solenoid when changing the function 5–25
Replacing components for cylindrical locks 5–26
Removing and reinstalling the solenoid 5–26
Removing and reinstalling the RQE rose liner for cylindrical locks 5–26
Removing and reinstalling the door status switch and magnet assembly for
IDH Max Cylindrical Locks 5–28
ADDITIONAL SERVICE AND MAINTENANCE FOR IDH MAX
L
OCKS 6–1
Replacing wire harnesses 6–2
Removing and reinstalling the sensor and solenoid wire harness 6–2
Removing and reinstalling the reader wire harness 6–3
Removing and reinstalling the field wire harness 6–5
Replacing the control electronics circuit board 6–8
Replacing the reader circuit board assembly 6–9
Replacing readers 6–11
Removing and reinstalling the magnetic stripe swipe card reader 6–11
Removing and reinstalling the magnetic stripe insertion card reader 6–13
Removing and reinstalling the proximity card reader assembly 6–14
Replacing the panel interface circuit board 6–17
GLOSSARY A–1
I
NSTALLATION INSTRUCTIONS B–1
I
NDEX C–1
Comentarios a estos manuales