BEST ACCESS SYSTEMS 35HW Manual de servicio descargar pdf (Pagina 108)

Service and Maintenance for Mortise Locks

4–54 W Series Service Manual

5. Remove the door status switch from the clamp.

Reinstalling the door status switch

1. Install the new door status switch in the clamp so that the door

status switch rests just behind the armored front of the case.

2. Route the door status switch wires or cable as shown in Figure 4.52.

3. Clamp the door status switch wires or cable in the strain relief. Slide

the strain relief into position on the case. It should lock into place.

4. Reinstall the mortise case cover and case spacer. See Task H. To

reinstall the mortise case cover and case spacer: on page 4–48.

5. Replace the mortise case. See Reinstalling components for

IDH Max Mortise Locks on page 4–13 or Reinstalling components

for electrified mortise locks on page 4–32.

Figure 4.52 Replacing the door status switch for mortise locks

(IDH Max shown)

Door status

switch

Armored front

of the case

Door status switch cable

Clamp

Top-right corner

of the case

Strain relief

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 227 228

Sin comentarios

BEST ACCESS SYSTEMS 35HW Manual de servicio Pagina 108