
Service and Maintenance for Cylindrical Locks
W Series Service Manual 5–21
Task C. To remove the inside rose and rose liner:
1. Insert the solid, curved end of the spanner wrench in between the
rose and the sleeve, as shown in Figure 5.25. Pry the rose until it
pops off the liner.
2. Unscrew the two through-bolts, as shown in Figure 5.26. Save the
through-bolts.
3. If there is an RQE rose liner, disconnect it.
4. Slide the liner off the sleeve.
Figure 5.25 Removing the inside rose with the spanner wrench
Spanner wrench
Inside rose
Sleeve
Inside of door
Figure 5.26 Removing the two through-bolts
Through-bolt
Through-bolt
Liner
Inside of door
Comentarios a estos manuales