BEST ACCESS SYSTEMS 35HW Manual de servicio descargar pdf (Pagina 142)

Additional Service and Maintenance for IDH Max Locks

6–2 W Series Service Manual

REPLACING WIRE HARNESSES

Removing and

reinstalling the

sensor and solenoid

wire harness

Removing the sensor and solenoid wire harness

1. Remove the core and throw member. For mortise instructions, see

Task A. To remove the core: on page 4–3. For cylindrical

instructions, see Task A. To remove the core and throw member:

on page 5–3.

2. Use the appropriate bit driver to remove the security screw from the

access door. Open the access door and remove it from the inside

escutcheon.

3. Remove the inside lever/knob. For mortise instructions,

see Task B. To remove the inside and outside levers/knobs: on

page 4–4. For cylindrical instructions, see Task B2. To remove the

plain lever/knob: on page 5–4.

4. Remove the upper and lower escutcheon screws from the inside

escutcheon. Pull the inside escutcheon away from the door enough

to expose the control electronics circuit board.

Note: You can let the inside escutcheon dangle from the field wire

harness while completing this task.

5. Disconnect the three sensor connections and the solenoid

connection.

6. Disconnect the sensor and solenoid wire harness from the control

electronics circuit board.

Figure 6.1 Disconnecting and connecting the reader wire harness (cylindrical lock

shown)

Inside of door

Reader wire harness

connector

Sensor wires and

solenoid wire

Inside escutcheon

Large opening

Solenoid and sensor

wire harness

Control electronics

circuit board

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 227 228

Sin comentarios

BEST ACCESS SYSTEMS 35HW Manual de servicio Pagina 142