BEST ACCESS SYSTEMS 35HW Manual de servicio Pagina 151

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 228
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 150
Additional Service and Maintenance for IDH Max Locks
W Series Service Manual 6–11
REPLACING READERS
To replace a proximity card reader assembly, the following new parts
are needed:
proximity card reader (B64404 for HID; B64403 for Motorola)
outside escutcheon gasket (A60725).
To replace a magnetic stripe swipe card reader, the following new
parts are needed:
magnetic stripe swipe card reader (B63269)
outside escutcheon gasket (A60725).
To replace a magnetic stripe insertion card reader, the following new
part is needed:
magnetic stripe insertion card reader (B61646).
Removing and
reinstalling the
magnetic stripe
swipe card reader
Removing the magnetic stripe swipe card reader
1. Remove the core and throw member. For mortise instructions, see
Task A. To remove the core: on page 4–3. For cylindrical
instructions, see Task A. To remove the core and throw member:
on page 5–3.
2. Remove the inside and outside knobs/levers. For mortise
instructions, see Task B. To remove the inside and outside
levers/knobs: on page 4–4. For cylindrical instructions,
see Task B1. To remove the keyed lever/knob: on page 5–3.
3. Use the appropriate bit driver to remove the security screw from the
access door. Open the access door and remove it from the inside
escutcheon.
4. Remove the outside escutcheon. For mortise instructions, see
Task D. To disconnect the connections and remove the outside
escutcheon: on page 4–6. For cylindrical instructions, see Task D.
To disconnect the connections and remove the outside escutcheon:
on page 5–4.
5. Remove the escutcheon gasket from the outside escutcheon and
discard the gasket.
6. Unscrew the two reader electronics mounting screws on the reader
circuit board assembly and remove the harness clamp. Save the
harness clamp and screws.
Note: You can carefully set aside the reader circuit board and sounder
affixed to the outside escutcheon.
7. Remove the four reader assembly mounting screws. Save the
screws.
Vista de pagina 150
1 2 ... 146 147 148 149 150 151 152 153 154 155 156 ... 227 228

Comentarios a estos manuales

Sin comentarios